2005-2015 Nissan Xterra JDM VQ40DE | 4.0L V6 DOHC Engine

Vehicle Fitment

This engine is a direct long-block replacement for the following North American N50 Generation models:

• Nissan Xterra: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015

• Trims: X, S, Off-Road, PRO-4X, SE

• Chassis Cross-Compatibility: Also serves as a high-quality donor for 20052012 Nissan Pathfinder and 20052019 Nissan Frontier (4.0L models).

• Compatibility Note: This engine is for 4.0L V6 models only. Not compatible with the 2.5L 4-cylinder or European diesel variants.

JDM to USDM Installation & Swap Guide

To ensure 100% compatibility and a seamless “Plug-and-Play” installation into your USDM Xterra, professional installers recommend the following “External Swap” steps:

1. Intake & Exhaust Manifolds: You must transfer your original USDM Intake Manifold and Exhaust Manifolds. JDM versions may have different vacuum line routing or lack specific emissions ports required for North American smog compliance.

2. Engine Sensors: Transfer your original USDM Camshaft Sensors, Crankshaft Sensor, and Knock Sensor to the JDM block to ensure the ECU receives familiar signals and prevents Check Engine Lights (CEL).

3. Wiring Harness: Always retain and use your original USDM Engine Wiring Harness. JDM harnesses are configured for right-hand drive and will not interface with your chassis or fuse box.

4. Oil Pan & Pickup: Inspect the JDM oil pan; if your Xterra is 4WD, you must swap your original USDM Oil Pan and Pickup Tube to ensure proper clearance with the front differential and subframe.

5. Flywheel/Flexplate: Transfer your original flexplate (Automatic) or flywheel (Manual) to the JDM crankshaft to ensure proper starter engagement and crank sensor alignment.

6. Water Outlet: Swap your USDM rear coolant crossover pipe and heater hose outlets if the JDM angles differ for your specific heater core lines.